[WANTED] 1971 340 valve covers

-
Status
Not open for further replies.
I have a set I took off my 71 340, there were on motor for a while, I then went to a cast valve cover. Unfortunately there buried in the garage and will take a little time to get to them. If you can wait I'll eventually get to them may be after Christmas.
 
As soon as I get them out I'll post a picture of them. Merry Christmas to you also.
 
I dug out the valve covers and not too bad for 50 years old. Gasket rail was even fairly straight. I don't have any of the pieces other then what is on the V.C..
DSCN6894.JPG
DSCN6897.JPG
Looking for $75.00 plus shipping.
Let me know and PM address.
 
This is what I was told is correct
Looks like your passenger side is newer.
I will take to get the drivers side if bracket will straighten out & be correct measurement

image.jpg


image.jpg
 
That piece you measure, on mine the last 1/2" is bent 90* to the upright. The upright is 1 3/4" and then the 1/2" bend. The car was bought in August of 71 so the the pass. side may be a later model. I will only sell as a set. The parts book shows only 1 # for 71 covers and a different # for 70's valve covers.
 
Last edited:
Status
Not open for further replies.
-

Back
Top