Fitting needed to use braided fuel line

C2ndLTpigeon said

Looking to see if anyone has used and Edelbrock 8123 braided fuel line with a stock mechanical fuel pump. I was a bid disappointed as I had asked a question on summit if it would work with a stock mechanical pump and the other end to an edelbrock filter at the carb.

Behold it does not fit at the fuel pump. Any suggestions on where to find a fitting? I had no luck at home depot.

Here is the line:
View attachment 1715665324 View attachment 1715665325 View attachment 1715665326

Click to expand...

A stock fuel pump uses different fittings than some of the aftermarket pumps so you need to figure out what you have before you can figure out what you need. And you aren't going to find AN fittings at Home Depot. Post a picture of your fuel pump and someone on here will figure out which fitting you need. My guess is that you'll need an inverted flare to AN which is actually a fairly special fitting. NAPA might carry a fitting like that but not Home Depot. More likely you'll need to order from Summit or find a race car place in Riverside that carries AN fittings.