Speedmaster intake porting. Hopefully I can make something out of this

Wow this thing needs major help and I honestly don’t know if it’s doable. I will post up flow numbers hopefully later tonight. This thing at .500 lift is sucking well over 50 plus horsepower out of my ported heads. At first glance it doesn’t look bad as far as gasket matching but it appears to taper in badly past the entrance. Matt and I both use the Mr Gasket intake gasket number 7276. View attachment 1715671554 View attachment 1715671555 View attachment 1715671556 View attachment 1715671557 View attachment 1715671558 They cost around 19.00 from Summit. I figured I better order a new Foredom hand piece since I have been porting more lately. I had not having spares. Here are a few pictures of gasket layout and a couple getting opened up.
Do you worry about the air coming from the intake “stalling” when it gets to the gasket and heads since the port appears to open so quickly right before the gasket area?

Thanks for doing this, looking forward to learning a lot!