273 Electronic Ignition Issues

67Dart273 said
OK. When you install the new module, make sure it is grounded to the case.

I said that the diagram Halifaxshops posted was incorrect. Only the yellow is incorrect. Regardless of color (usually brown) this wire gets power in "start" from the brown/ bypass/ IGN2 terminal of the key. So if you note that it is in fact correct

View attachment 1715690057

Looking at that diagram and comparing it to mine, then it's wired correctly. So now I just need to put the components back together and try firing it up. Yes, I'll need to clear the area of any paint, use the correct washers as previously recommended, same with the larger screws to make sure it's grounded properly.