supersoap33 said

Thanks for the pic. I'll remount the ignition control module then see if there is a hole behind it where I can mount the ballast resistor.

And to the other post, yes... I'll make sure to wire wheel all the paint off of the fender behind where the ignition control box will go to make sure it has a good ground.

Does anyone have a closer picture detailing the wiring harness around that corner area on the driver's side near the firewall? It would be nice to have a pic of the wires as they are so I can know what needs to go where in terms of wiring the ballast resistor back into the circuit.

Click to expand...