Stop in for a cup of coffee

And I have an update on the wheel situation. Only option is a spacer at this point. I even called the manufacturer and basically I’m stuck with them. Even though they admit, the wheels aren’t to the spec they advertised

I took out the micrometers today, albeit the cheap ones. And my bore gauges.

the rotor hub diameter is 70.00 mm(spec called for 70.3) the rotor hub height is 33.58 mm.
The wheel center bore measures dead on to spec at 70.6mm from the rear. However, at 27.40 mm from the mounting surface is an inside step that retains the center cap, from there, outward to the front of the rim, it tapers down to 70.11mm.

the problem is, this also tapers on the outside, there’s only 6 mm difference between the inside diameter and the outside from the step forward. So machining isn’t gonna work on the wheel. I confirmed that with the wheel shop in Louisville.

machining the hub also won’t work for the same reason.

so looks like I’ll be selling these rims . Which sucks cause it took me 2 years to settle on these.

Or I may run a 6mm spacer amd longer studs