Cam Specs.....where will the power be?

Garrett Ellison said

You're right on with that one with the hydraulic rollers being vastly different from their flat tappet counterparts. Light switch like opening when compared to even the most efficient flat tappet grinds. Comp shows a 110 LSA on their website, but it's that 38 degree ABDC closing that makes it such a forgiving piece. I didn't think about it until I looked at the cam card at the bottom of the page and the 110 LSA, but a question for Rusty. Do you think an additional 4 degrees of advance would make it a little more goal friendly with off idle power?

Click to expand...

Oh is the thing ground on a 110? What are the new valve events for that? I'm way too lazy to figure it out....or more appropriately, I don't give "enough of a ****".

That said, if it's ground on a 110, then perhaps, there goes his pump gas motor. Because that's gonna affect the IVC event and not in a good way for pump gas. Now, if it was actually ground on a 114......which Comp WILL DO, then I'm all over it for this combo.

My bad. I slap missed that.......and I shouldda known better, because Comp slobbers all over 110 LSA like a cheap slut on a chocolate covered dick.