1963 Dart 170 2 Door Post Resto

Getting closer...

Got the other drip rail stripped and cleaned and the other rocker cleaned up. Unbolted the bottom of both front fenders so I could clean up behind them as well.

Looks like all I have left is the rad support area and the rest of the cowl vent slots, then a little hand sanding in tight corners here and there and then it's time to clean the shop, wipe everything down, and spray some epoxy primer on the shell. Doors, hood and trunk lid will be done after as I will need to move the car out of the way to set up the stands to spray them. Then I plan to spray inside the fender/door jamb area and hinge area of the doors with sealer and paint before install as I don't see getting a good angle to spray them properly when done. Not looking for perfection, just a nice complete solid color. It's going to be a driver, otherwise, fenders would be off too, mind you they are really clean underneath anyway.