IDK how much lift it takes to coil bind 318 springs on a /6 but this cam that I am wanting to run is right around .435 -. 440" lift. This is for a truck that will be used like one, I doubt it'll ever see 4000 rpm.
It would be interesting to compare notes when you get done with your truck and I get done with mine. I just did a complete .030 rebuild on the bottom end. It has an OCG 2106R grind cam properly degreed in. I gave the head a home pocket porting with a set of Engine Builder valves, 1.70 intake and 1.44 exhaust. It's getting a super six setup with a Carter BBD and the exhaust outlet opened up to a tick under 2-1/4". Single 2-1/4" exhaust out the back. The head is getting shaved .060 for compression to about 8.5:1 static for about 7.5:1 dynamic. I'm keeping the 833OD trans. Like your truck, this is for dump runs, getting gravel/firewood, and hauling my trailer around so I can buy more Mopars!
