Does anyone have pictures on how these clips fit on car to hold trim and a good closeup picture of clip. I didn’t tear this apart and not sure how clip is to hold trim. Also is there a cushion strip under stainless
take a look at the pictured clip in the first post. Remember first that the slotted hole is for the screw that holds down the trim piece, so that faces up. Then you will realize that it only clips on one way. Most every time you should start from the center and work your way out, put the trim on the edge of the lip, find the center and put that clip on, and work your way around, using the trim as a road map as to where they go. The slotted hole will help if you get them a little off. When you screw the trim on with the snap caps, the screw will catch the hole, and as you tighten it, it will raise the clip up as it follows the threads, and sort of bind the bottom teeth of the clip to hold it in place.
There’s no strip that I know of under the stainless, and the trim is deep enough to not allow the tip of the screw touch the body, and pulling up the clip with the screw also pulls the trim sown to the body.
