318 head porting for the average joe

Ok
no on want to bite.
so here is MY! shORT answer.
The first time porting should be a focus on cleaning up the port, NOT porting aka changed the port design. (LEAVE THE SSR ALONE!!!!!!!)

3 angle valve job with the 65 degree cut, opening up the bowl area (under the valve) on the intake side.
Light clean up on the exh side. AND CALL IT GOOD!!!!

It's simple and quick and rewarding.................from there on, for a beginner, you can take away every think you just created by what i stated above.

There that should cause some opinions to flow:)