column to floor shift

When I did my conversion I found the measurements here on FABO and I used 3M panel bond to glue in the brackets just in case the measurements were off I could somewhat easily remove them. From my experience with the installation there is some wiggle room for your console location built into the brackets. My brackets are original that I bought off eBay so I cant speak to AMDs quality or fitment but if they are modeled after the original pieces they should be fine. If you cant find the measurements something you can do is Install your shifter then install the brackets on the console and place it in the car, make sure the car is in park and line up the "P" on the console with the shift lever then using a sharpie you should be able to mark the brackets location on the floor pan and get a general location to where the brackets mount then gently as to not move the console shift through all the gears verifying the alignment of the gears detents to the console gear markings and the side to side alignments of the console that should get you pretty close. Good luck