Moser 60

Duane said

I decided to do the perches at home myself to make sure it's right and have a local fabricator weld them. I did not want to risk them screwing up the angle and the perch width.
Just me but that's how I am doing it. Once I know it's right, then off for powder coating.
I also just ordered one of these.
Should come out just under the back bumper at 48 inches.
(Training wheel lol)

View attachment 1715710430

View attachment 1715710431

View attachment 1715710432

View attachment 1715710433

Click to expand...

Yeah I don’t quite qualify for one of those skateboard wheels yet. Maybe with the hemi it’ll need a set.

I did the relocation and perches myself a few years ago. Unfortunately I wasn’t thinking correctly, and put a 0* angle on my pinion. This time I want the pinion down 2 degrees at least. Was thinking of asking for 4 degrees, then shimming it back 2 if I need to. Those caltracs must rotate up a little bit under hard acceleration.