Thanks Dave. No issues with warpage on the doors or fenders? Any idea what media they used?
i think he used walnut shells, it was a long time ago. i wouldn’t blast a hole car, it’s too hard to get the sand out.Thanks Dave. No issues with warpage on the doors or fenders? Any idea what media they used?
got a little more work done this weekend, air compressor blew up so that slowed me down a bit. that’s life lol .
View attachment 1715703768
View attachment 1715703769
View attachment 1715703770
View attachment 1715703771
looks familiar......Hope the pure-breads don't mind if it doesn't go back together 100% like the factory made them. I like
Keep up the good work...we are watching you.
View attachment 1715703794
I’m just trying to turn it back into a car again on a low $$ budget . No pure breading going on here . What ever crap i have laying around the shop is what’s going on the car lol.looks familiar......Hope the pure-breads don't mind if it doesn't go back together 100% like the factory made them. I like to move stuff around a little.
Keep up the good work...we are watching you.
View attachment 1715703794
That's how we did it back in the early '80's......Best time of our livesI’m just trying to turn it back into a car again on a low $$ budget . No pure breading going on here . What ever crap i have laying around the shop is what’s going on the car lol.
thanks , my skills aren’t that great, i just fail till i get it right . I went to school to learn autobody basics. They did really teach us how to rebuild a whole car body full of rust though. My teacher told me to buy a car with no rust. lmao !Envious of your fabrication skills
Me too..I was hemming and hawwing about buying a Duster that needed a lf frame rail..I walked from it ,I figured it would sit and sit and sit before i got to it.Envious of your fabrication skills
the problem with rust in these cars is it gets between all the panels. it’s hard to see how far it goes until you start cutting into it. my car didn’t look that bad at first. I’ve ended up replacing 2/3rds of the sheet metal.Me too..I was hemming and hawwing about buying a Duster that needed a lf frame rail..I walked from it ,I figured it would sit and sit and sit before i got to it.