Engine Builders-KB356 Piston Milling

thomasfouraker said
I am (on average) .085 in the hole. Low .081 high .089 averages after checking 4 spots on each piston then averaging those.

Will CC the cylinder hopefully tomorrow. I suspect 62-63cc. Should put me 9.2-9.5 if so with dynamic compression of 7.7-7.9
Click to expand...
Good.
Once you cc it, you'll know.
Based on what you said and considering the quench head milled off down to the dish 'adding a guesstimate of 3cc'

Screenshot_20210407-151941_Samsung Internet.jpg