Has anybody used these axle seals from Winters Performance???

I was attempting to install them for a long term rear end project

Ive got to the point of grinding the inside of the axle tubes a bunch and get them to fit in. But that’s as far as I got.

BUT Tim at Alltimeracing.com said he installed and ran them. And they didn’t work well. He said the tubes are not centered to the axles in that area. So they were offset some.

Its tough to tell with just the axles put in cause they need to be supported by the center section.

I do know the “tubes” seem to be stamped, formed, and welded. They are lumpy and wavy. there are all kinds of welds and slag on the inside.

Not like a tube steel for pipe or pressed in axle tubes like Dana’s and 8 1/4’s.