3/8 sender pick up tube conversion
Finnish and tested and gets the green tick.
On these senders the send wire is insulated from the body ground, the factory did this with a nylon washer on the outside , rubber and a fibrous washer on the inside held together with a copper brass rivet. So what i did here is replace the rivet with a 3mm ss button head screw and nylock nut and a little thread sealant to prevent fuel from following the thread path out, replaced the resistor card and buttoned it up.
I also had some outside washers 3d printed out of different materials for testing and future projects, nylon and resin has held up to fuel but the ASA failed.
Finnish and tested and gets the green tick.
On these senders the send wire is insulated from the body ground, the factory did this with a nylon washer on the outside , rubber and a fibrous washer on the inside held together with a copper brass rivet. So what i did here is replace the rivet with a 3mm ss button head screw and nylock nut and a little thread sealant to prevent fuel from following the thread path out, replaced the resistor card and buttoned it up.
I also had some outside washers 3d printed out of different materials for testing and future projects, nylon and resin has held up to fuel but the ASA failed.
