Rain gutters and body seam sealers

Thanks again for the tip. Went out yesterday and picked up 2 tubes. NAPA had it at the NAPA paint supply store close to me, and as luck would have it, it was on sale. Still cost $50, but better than $75 a tube. Hoping to get it in primer in the next week or two, then apply the seam sealer from there. Hoping to see color on it by early spring if time and money allows.

So, I finally got to the point to apply seam sealer. I must say that it went pretty good. Of course I decided to try using my regular gun to apply it. I won't do that next time. Like stated SUPER hard to get it out of tube with a regular gun. Do yourself a favor and buy the high ratio gun to apply it. And yes, it dries rock hard. This stuff isn't going anywhere. Did the entire exterior over and all of the trunk and rear seat area. As for front area there was some areas that were not shrunk and holding like new so I left those and only applied it where I removed the loose sections. Should last for another 50 years. :)

Thanks again for the suggestions

back floor sealer.jpg

Front floor sealer.jpg

rain gutter sealer.jpg

RH body sealer 1.jpg

RH body sealer 2.jpg

trunk sealer.jpg