my slant buildup

My .060 over block was decked to .130" over the pistons, the head was cut .055", & using a Print-o-seal gasket it cc'd at 9.47:1 with the carbon, 9.35:1 after I cleaned everything. If You want to run that #819 OCG cam, this # is going to serve the torque below 2800 well. Or You can buy a converter that stalls at 2600+ & You're golden. The 2106R is a better torque cam, it will make a higher peak #, but less hp 3.5k & up. If You bump the CR to 9.5 You gain back 80% of the tq deficit to the 2106R, & match it at 3k. Peak would be just a tick higher as well.
Those were modeled with the same head, 8.8:1, int/exh systems.