833 4spd repair advice

I can tell you I learned alot in my early years at my own expense on my own cars...eventually i went to trade school and ended up wrenching for a living but in the beginning was alot of trial and error. OP dont thtink you are the first to have done this .I fried my input shatft bearing doing the same thing,in my case it seized,the engine wouldnt turn by hand with the clutch in. I found it needed input shaft bearing, which needed to be pressed on. so, you will need a press to remove and install that bearing. like said its a learning experience for you. you will never run a trans without oil again I guarantee that you wont forget.