New Ultrasonic Cleaner
No
I either put the small parts in the cage, or larger parts directly in sitting on the bottom, like the 4 bbl carb bases.
No need to suspend them.
I do suspend my parts with a wire when I am doing the Zinc Plating Process, because the parts need to attract the Zinc from 360° for even coverage. Not needed in the Ultrasonic Cleaning process because the whole solution is vibrating all the same, up down, left and right.
___________
Someone was talking about putting parts in a vase or container. I tried this thinking with the Vinegar in the smaller container so I would not have to use so much vinegar and waste it just for the small parts.
Then I set the vinegar container into my tank with the Pinesol Solution, then I did not need to change that out either. It all vibrates the same as one.
Time to finally change out my Pinsol Distilled water mix now, after many various materials and experiments, getting pretty dirty time to start fresh again.
No
I either put the small parts in the cage, or larger parts directly in sitting on the bottom, like the 4 bbl carb bases.
No need to suspend them.
I do suspend my parts with a wire when I am doing the Zinc Plating Process, because the parts need to attract the Zinc from 360° for even coverage. Not needed in the Ultrasonic Cleaning process because the whole solution is vibrating all the same, up down, left and right.
___________
Someone was talking about putting parts in a vase or container. I tried this thinking with the Vinegar in the smaller container so I would not have to use so much vinegar and waste it just for the small parts.
Then I set the vinegar container into my tank with the Pinesol Solution, then I did not need to change that out either. It all vibrates the same as one.
Time to finally change out my Pinsol Distilled water mix now, after many various materials and experiments, getting pretty dirty time to start fresh again.
