[WANTED] Upper control arm

-
Status
Not open for further replies.
Lee Robinson said:
PM sent
Click to expand...
Here is what my control arm looks like.

IMAG0631.jpg
 
SGBARRACUDA said:
The one in the picture looks like a passenger A arm. You sure on which one you need?
Click to expand...
Yes, that is the one I need to replace. When I installed it, it was difficult to get back in, and it binds up. I think the shop I had press the bushing in placed it on end, and bent it. If you look close, the cam bolts look out of alignment. I didn't notice it before I installed it.
 
GSXcite said:
Yes, that is the one I need to replace. When I installed it, it was difficult to get back in, and it binds up. I think the shop I had press the bushing in placed it on end, and bent it. If you look close, the cam bolts look out of alignment. I didn't notice it before I installed it.
Click to expand...
You know you can manipulate the ears a little bit to make then fit a little better. Won’t hurt a thing.
 
SGBARRACUDA said:
You know you can manipulate the ears a little bit to make then fit a little better. Won’t hurt a thing.
Click to expand...
The shop used a press to install the bushings, and must have put alot of pressure on it without supporting the ear. I don't think I can straighten it with just a BFH. I wish I could since I restored it and will have to do it again to used part.
 
Status
Not open for further replies.
-

Back
Top