[Found!] Non ac heater box clips

-
Status
Not open for further replies.

jonnyrose

Well-Known Member
Joined
Aug 30, 2017
Messages
227
Reaction score
89
Location
canada
Rating - 0%
0   0   0
Contact seller
..................looking for 7 large heater box clips on the cheap,hard to get where i live,

s-l300.jpg
 
Be careful when reinstalling, make sure to take some tension off of them. There is no need for them to be as tight as they were. Could break the plastic very easily, trust me lol.
 
My box was all cracked warped,and only had 4 clips left,I restored the fiberglass and have made all new seals,but most of companies aren't shipping to Canada right now,do to lost packages or broker fees. if I can figure out how to make those clips I will but thought I'd ask here first,
 
I have a drawer full of them . PM me your address and how many you need. You cover the shipping and I will send them out. I stopped doing this due to getting stiffed for the shipping. You will be the test for retrying to trust people on this site. I'll ship them you pay me when you get them. Honesty goes a long way

When installing them you don't just push them on. Stick the single end in place insert a flat screw driver in the double end and pry back while pushing them in place. I always would squeeze them and make them tighter before install so they hold the box halves tight. They always seem to loosen up when removing them. You can hold the screw driver sideways at locations where you can't go dead on.
 
When installing them you don't just push them on. Stick the single end in place insert a flat screw driver in the double end and pry back while pushing them in place. I always would squeeze them and make them tighter before install so they hold the box halves tight. They always seem to loosen up when removing them. You can hold the screw driver sideways at locations where you can't go dead on.
Exactly what Oldmanmopar said.
 
Status
Not open for further replies.
-
Back
Top