The Dust-Turd project.
Mounted the chute release handle yesterday. Didn't want to weld the tabs on the roll bar, so I made up a mount and clamped it to the cage. Also went thru the Lenco with Jeff from Esinlin Racing and changed the ratios to 38-36-34-28 or 3.22 first, 2.33 second, 1.71 third , 1.28 forth and 1.1 fifth. When you have no HP, you need alot of gear to move it. :thumbsup:
Had to move the shifter up one section forward so i can reach it and replaced all the rods and hiem joints/ bushings on the shifter. Set the shift pressures and it's smooth as butter.
CS3 goodness........
Mounted the chute release handle yesterday. Didn't want to weld the tabs on the roll bar, so I made up a mount and clamped it to the cage. Also went thru the Lenco with Jeff from Esinlin Racing and changed the ratios to 38-36-34-28 or 3.22 first, 2.33 second, 1.71 third , 1.28 forth and 1.1 fifth. When you have no HP, you need alot of gear to move it. :thumbsup:
Had to move the shifter up one section forward so i can reach it and replaced all the rods and hiem joints/ bushings on the shifter. Set the shift pressures and it's smooth as butter.
CS3 goodness........
