65 Barracuda Addco front sway bar install

I have installed several of the addco bars over the years in early a's its been a while since I did one so I will spell out what I had to do. Also you might get lucky as some 65 barracudas has the lower control arms with the sway bar bushing bracket already welded in place , its no big deal if it does not its just helpful if yours has that. . I never had to use the instructions as I just looked at what i did on one of my other cars to refresh my memory, so you dont really need the instructions. It is kind of self explanatory once you start to install it.

I like to start with by mounting the 2 sway bar end link brackets to the lower shock bolt- you need to remove the bolt to install the bracket. YOu can skip this step if you LCA already have the mounting tab from the factory.

next I assembly the links and the bar on each side

I get a bottle jack , floor jack or what ever you have to raise the front of the bar in the position that it calls for , i want to say it need to angle down as you go back to the links so the front of the bar is higher than the links , not by much though. Oh yeah you will need to remove the k frame to valance panel brace to get the sway bar high enough.

Next take the mounting brackets and look for a place for them. here you may be in luck as well as some 65 cuda k frames hav the indentations on where the factory bolts would go to hold the factory sway bar. If you have those then that is where you need to mount the bar brackets.

You will need to mark where you want the brackets and mark where you need to drill the holes in the k frame for the mounting hardware. I believe you need to dril 2 holes one on the bottom of the k frame for another mounting bracket and another on the face of the k frame to mount the lower bolt, I think the upper part does not require a hole to drill. it should start to make sense from that point forward

Its really pretty simple install should not take more than an hour. I will upload photos.