Small block stroker

Also, even though those sealed power pistons are cast, they are surprisingly strong. Certainly strong enough for a 75hp shot of spray if you provide adequate ring gap and piston to wall clearance, and as always with nitrous, avoiding detonation is paramount. What are the cc's of your J heads you have around, and what do the chambers measure across at the narrowest point? I'll go ahead and figure out which head gasket you need and the compression on the 3.58 stroke engine if you can get that information for me. If you were closer, I would have you in 318 hydraulic roller cam block that the stock bores would torque plate hone back to round in and a 360 crank that needs turned before you could blink.