[FOR SALE] Misc small block

-
Status
Not open for further replies.
99CENTS

99CENTS

Well-Known Member
Joined
Feb 1, 2012
Messages
143
Reaction score
37
Location
PA
Rating - 100%
1   0   0
Contact seller
Misc small block and a body parts.
Set of hooker headers ceramic coated new in box w/power steering. $400.
360 engine with all bearings rings and gaskets to assemble. Heads redone with 2.02 valves.....$900.
,727 for small block probably will need rebuilt..$50

IMG_20210709_101213.jpg


IMG_20210709_101127_1CS.jpg


IMG_20210709_101033.jpg


IMG_20210709_101103.jpg


IMG_20210709_100847.jpg
 
Do you know what year the 727 is from? I’m looking for a 71 small block 727.
 
If you take a wire wheel to the rail on the passenger side just above the trans pan there will be a set of numbers and the numbers will indicate the 10,000 calendar date code.
 
It should read PK then 7 digits which is the part number. Then the next 4 digits are the date it was built in the 10,000 day calendar. I’m looking for 3400-3850.

Thanks Jim
 
Has the 360 had any block work, is it a complete engine crank rods pulleys ect
 
360 detail questions:
Is the block standard bore and your plan was to just hone and re-ring it?
Or does it need boring and you bought over size rings ahead of that?
Crankshaft is polished already and the bearing are standard or oversized?
Or the crankshaft needs to be polished or maybe ground undersize and you preemptively purchased the main and rod bearings
Are the new valves stainless?
Were the valve guides replaced or just knurled?

Thank you
 
1966Post said:
360 detail questions:
Is the block standard bore and your plan was to just hone and re-ring it?
Or does it need boring and you bought over size rings ahead of that?
Crankshaft is polished already and the bearing are standard or oversized?
Or the crankshaft needs to be polished or maybe ground undersize and you preemptively purchased the main and rod bearings
Are the new valves stainless?
Were the valve guides replaced or just knurled?

Thank you
Click to expand...
Everything on motor is stock cylinders where honed.
Not sure what shop did to guides or what valves they used. Spring are matched to cam shaft
 
Status
Not open for further replies.
-

Back
Top