Ballast Resistor By Pass Chrysler Valiant

The Crane Hi-6 is a CD ign, connects differently than inductive ign like HEI.

Your coil should be connected to two dedicated wires that exit the box, marked coil - & coil +. No other wires should be connected to the coil.

Heavy red wire goes direct to bat + terminal. Heavy black goes to bat - [ ground ]. Thin red wire gets switched ign. Easiest way to hook up so that you do not make a mistake is to remove the wires going to the two spade lugs on the resistor, connect these wires together & then connect the thin red wire to these wires. Resistor can be removed if desired, no longer needed.