1972 Dodge Colt
Clearance on Intake is close.
For now just going to a thicker head gasket.
Ordered 1 custom push-rod from Smith's Brothers to check fit on rockers.
If it works I will get a set made.
It's hard to measure something 10 inches long accurately.
I put a set of head studs on just to check if I could remove the head in the car.
It was a relief that I had room to spare under the cowl removing the head.
After some engine work I worked on my front driveshaft loop.
It was too short for my engine install.
Clearance on Intake is close.
For now just going to a thicker head gasket.
Ordered 1 custom push-rod from Smith's Brothers to check fit on rockers.
If it works I will get a set made.
It's hard to measure something 10 inches long accurately.
I put a set of head studs on just to check if I could remove the head in the car.
It was a relief that I had room to spare under the cowl removing the head.
After some engine work I worked on my front driveshaft loop.
It was too short for my engine install.
