Modified Edelbrock MAGNUM RPM 7577
This is an RPM Air Gap intake that TXDart (Martin) either modified, had modified, or bought before he passed away a little over a year ago. It has been modified to run a Thermoquad, or other spreadbore carb. It's very well done, somebody put a lot of work into this unique piece! I think he intended to use it on an LA block 360 with Magnum heads that he was working on. All my stuff is LA, so I really don't have a use for it, and would like to see it go to a good home. Other than the carb flange mod, it looks to be like new. Every bolt hole looks great!
All the ports are as cast, not gasket matched.
I will also include a set of Mr. Gasket 308G graphite intake gaskets, that were in the box. They each look like there is a little crush around the edge of and divider between one set of intake ports, but would probably work fine. They are dead soft graphite like Remflex.
Asking $325 including shipping and paypal fees to anywhere in the lower 48.
This is an RPM Air Gap intake that TXDart (Martin) either modified, had modified, or bought before he passed away a little over a year ago. It has been modified to run a Thermoquad, or other spreadbore carb. It's very well done, somebody put a lot of work into this unique piece! I think he intended to use it on an LA block 360 with Magnum heads that he was working on. All my stuff is LA, so I really don't have a use for it, and would like to see it go to a good home. Other than the carb flange mod, it looks to be like new. Every bolt hole looks great!
All the ports are as cast, not gasket matched.
I will also include a set of Mr. Gasket 308G graphite intake gaskets, that were in the box. They each look like there is a little crush around the edge of and divider between one set of intake ports, but would probably work fine. They are dead soft graphite like Remflex.
Asking $325 including shipping and paypal fees to anywhere in the lower 48.
