I just ordered my Gear Vendors Overdrive!

I put one in an E body in 2005, and had to beat the hound out of the tunnel to get it to fit. I have heard the OD unit itself is a bit smaller now, so maybe yours will go in easier. You can buy an adapter u joint to go from the GM slip yoke that comes with it to your Mopar driveshaft, or just buy a new end for your driveshaft that matches the GM yoke since you will have to have the driveshaft cut anyway. I wired a bypass wire, to go from the foot switch to the shift solenoid…in case the electronic box takes a dump. The electronic box and the shift solenoid are the most problematic on the older units, so hopefully they have that all worked out by now. Good luck with the install….it ain’t that bad!