Easy Run Engine Test Stand

Finally moving forward with getting an engine on this thing...Have had some health issues that have slowed me down....but moving forward as tired on sitting on my ***...

Got a fuel pump mounted on the stand....hose to and from tank...and hose for the carb.....
Had to move 2 engines to get to the 360 that I want to run......got the plastic bag off it....to put on moroso electric water pump on it....that is went the old **** moment....No Water pump
so tomorrow I get the flywheel and bell housing mounted on the 360,,,,,motor is internally balanced...so i should be able to swing motor on stand ...going to slow go for first time...
got a little bit of wiring still ....hooking up starter...oil pressure line...

the motor needs to primed again....rockers tighten adjustment checked...intake bolted down.....I am using a DUI Hei distributor.....one fire for the coil and one wire for the tach....
and lastly remove inter spring LOL...trying to figure out which ported eddy head these are.....oh....they got the 2.08 intake valve done by Brian at IMM.....this is the set that ate and exhaust valve...valve head broke off..bean **** out of chamber
Has Hughes 6064 cam...with Holley SD....using Holley 750 dP,,,,,and see what header will fit....got a used set of TTi stepped headers i will want to use.
Icon 741 .030 pistons....decked.....true 10,50 compression....Scat I beam rods....internally balanced stock crank.

then we move on to the 390 and 410......