Trick Flow Intake for small block Mopar

Overall Height:

Indy - 7.125"
TF - 6"





The only thing that I can't figure out are the intake bolt holes. They're significantly larger than my other intakes. Not sure if this is deliberate or if they messed up. But they're 0.51" while my other intakes take a 0.375" bolt.



Aside from that, this should flow really nice. Ports look really good. There are a few small spots that I'm going to touch with the carbide bit, but I'm OCD. Most people wouldn't even notice.

Anyways. They're shipping. Hope this helps.

Does it have a date of manufacture on any of the packaging?
Bolt holes are probably a little larger to help fit differences in deck heights, so no grinding will usually be required.