Transmission Gear selector issues

Professor Fate said
Column shift, I have to assume.
Duster linkage, I also assume.
D250 trans. selector arm, again assuming.
Given the above, the selector arm on the (truck) transmission is most likely the wrong length to work correctly with the Duster linkage. Use the one off of the old /6 904 if you still have it.
If any of the above assumptions are not true, you will need to give more detailed info about your setup.
Click to expand...
Yes steering column shift not console/floor all linkage is not the truck all the rods are the 904 the torque tube is the 904 I have the 727 for this year but it looked identical to the 904 so didn't go through the work to change it. The control lever on the trans is is for the 727 not the truck none of the truck stuff would work.