4SPD TRANY INSTALL

When ever you install a different bell housing on a different motor the bell should be dial indicated to the crank. New or used they should be checked. Just had a friend destroy a new 18 spline from Passion because he didn't do this. It burnt the through out collar and the input blue from rubbing.

I already fought some like this I hooked the clutch linkage up and had someone push the clutch and it went right in.

The plastic alignment tools are not that great of a fit. I always use and old input shaft.

One thing I always do if I feel there may be an alignment problem is. After installed Leave the driveshaft off , Have someone put the car in 4th gear and hold the clutch pedal in . You should be able to install a yoke in the trans and turn it by putting a small bar in where the u-joints go. If you can't turn it you have binding.