[Found!] Early /6 flex plate

-
Status
Not open for further replies.
That might be gettin tough to find. I gotta pile of um. I'll look through um and see. I may have one.
 
Yes RRR , can you tell us the difference, I have one.
Thank you once again, most likely the center hole maybe
 
oldkimmer said:
Rob, what’s the difference? Converter size? I know the crank bolt pattern is different than a V8. Kim
Click to expand...
The center hole for the crank register is smaller on prior to 68.

And yes to the OP, I have one.
 
RustyRatRod said:
I have one.
Click to expand...
Good evening RRR, if it's not to much of a problem can you post a picture with what size hole and TQ holes, I would like to know for myself the cent hole size.
What would a bunch of us do with out good tech on this site :thankyou:
 
memike said:
Good evening RRR, if it's not to much of a problem can you post a picture with what size hole and TQ holes, I would like to know for myself the cent hole size.
What would a bunch of us do with out good tech on this site :thankyou:
Click to expand...
Sure Mike. Lemmie whoop out to the shop and measure um. Back in a few.
 
memike said:
Good evening RRR, if it's not to much of a problem can you post a picture with what size hole and TQ holes, I would like to know for myself the cent hole size.
What would a bunch of us do with out good tech on this site :thankyou:
Click to expand...
Mike, the small (pre 68) center hole is 1.960 and the large (68 and later) center hole is 2.160.
 
RustyRatRod said:
Mike, the small (pre 68) center hole is 1.960 and the large (68 and later) center hole is 2.160.
Click to expand...
Thank you very much Rusty :thumbsup:
I will look at my /6 box and see witch one it is.
I bought a box full of parts years ago here
 
Status
Not open for further replies.
-

Back
Top