Who Knows Correct Screw Size for Tail Light & Reverse Plastic Lenses?
The #8 wood screws I picked up are both good and bad. They have very few threads per inch, which will prevent them from likely splitting the plastic lenses. However, with so few threads they just barely hold on.
By holding the screws in a pair of pliers, the part sticking out was about the perfect size for cutting off with Dremel tool cutting disc. For one of the red lens screws where the boss for the screw is deeper, I just cut off the very tip.
The #8 wood screws I picked up are both good and bad. They have very few threads per inch, which will prevent them from likely splitting the plastic lenses. However, with so few threads they just barely hold on.
By holding the screws in a pair of pliers, the part sticking out was about the perfect size for cutting off with Dremel tool cutting disc. For one of the red lens screws where the boss for the screw is deeper, I just cut off the very tip.
