Plug Wire Routing w/ Fab'd Valve Covers
I used 3M HD hook and hook (peel and stick). The whitish/clear one with no male/female sides. I used a flat bottom wire separator on each bank and put a strip on the bottom, located where on the valve cover it would lay and put a piece there. 5000 miles 24 passes, it was still holding tight when I changed drivetrains and is still on the engine now.
I used 3M HD hook and hook (peel and stick). The whitish/clear one with no male/female sides. I used a flat bottom wire separator on each bank and put a strip on the bottom, located where on the valve cover it would lay and put a piece there. 5000 miles 24 passes, it was still holding tight when I changed drivetrains and is still on the engine now.
