My next crazy project.
As promised here are some pics. I finished tearing the engine down the rest of the way this morning. I found a small crank at top of the case (now the side) looks like the crank smacked into the case somehow. Easy fix tho. I took a ball peen and knocked it back flush and I will clean and jb weld the crack. I also have to jb weld the old governor hole and dipstick hole closed. I can't believe how tiny that piston is its so cute lol. I don't think I have a ring compressor that small. I may have screwed up there I may have to buy a small ring compressor. Im gonna port the head some and lap the valves. I already cleaned them up with a wire wheel. Im gonna run a open header style exhaust and may open the jet up a tiny bit to try and increase flow. I might gain a couple points in hp. Make it a 4.8hp instead of 4.5 lol im working on a 45 degree intake now. This carb is a little different it just snap fits into the intake with a rubber o ring. Im thinking about a 3/4 rubber hose and then modify the bracket to hold it level. The rubber hose fits right over the intake perfectly i just gotta figure out a way to get it attached to the carb.
As promised here are some pics. I finished tearing the engine down the rest of the way this morning. I found a small crank at top of the case (now the side) looks like the crank smacked into the case somehow. Easy fix tho. I took a ball peen and knocked it back flush and I will clean and jb weld the crack. I also have to jb weld the old governor hole and dipstick hole closed. I can't believe how tiny that piston is its so cute lol. I don't think I have a ring compressor that small. I may have screwed up there I may have to buy a small ring compressor. Im gonna port the head some and lap the valves. I already cleaned them up with a wire wheel. Im gonna run a open header style exhaust and may open the jet up a tiny bit to try and increase flow. I might gain a couple points in hp. Make it a 4.8hp instead of 4.5 lol im working on a 45 degree intake now. This carb is a little different it just snap fits into the intake with a rubber o ring. Im thinking about a 3/4 rubber hose and then modify the bracket to hold it level. The rubber hose fits right over the intake perfectly i just gotta figure out a way to get it attached to the carb.
