Cut wires and missing part harness - nothing major though, phew

Hi Dana67Dart + everyone else. Yes, the small dome lights just above the floor pan under the arm rests on both sides. Maybe someone was looking for some privacy whilst on the back seat, who knows. Sure, I'll just join them back up as I found a cut length 12" or so long behind the rear seat. Very odd. Yep, figure I'll just buy the trunk light/switch harness from the connector near the top motor and splice it in. Was tongue in cheek on the wiring colour; I have to battle a dingy garage, crap lighting and like you say 50+ years of road grime. I look for continuity too for confirmation where I need it. My rig is a non-AC car so I can see the empty bulkhead terminals for the motor and compressor and fortunately do not have any wiring hanging in the wind (that I cannot trace from/to something so all good there).

'69 Dart convertible /6 225 (Y2/X1) was imported into Australia in 2017 and I have yet to determine from where yet as it's passed through a couple of owners down here since then. I don't know why as this car is a little ripper, granted with a lawn mower engine but it's 95% or so complete with minimal rot. Am looking forward to kicking off a great little project.

Will get the car out into some daylight this weekend and take some decent photos for you guys.