Morning Mopar movers and shakers. 29 here, mid 50s this afternoon. Hope they let your gal come over here for a visit.
Stop in for a cup of coffee
- Thread starter toolmanmike
- Start date
-
I saw
So much for a rebilt trans!
With the GV unit installed will be real tough to pull tail shaft. I guess I will find out.... No room to move unit to the rear...cannot remove unit from t ailshaft because of top fastener s
Why can’t you get it off? The GV?
Beat me to it, but wow. Hate to say it, may just be easier to drop the trans out bs spending extra time an stress trying to invent a way to do it otherwise
Not enough room to pull it back...
No way to drop the trans. Same issue. Engine needs to be dropped. And now with new exhaust have to remove rear axle to remove because of pipe over axle. Really pissed
Ouch. Can you take the pipes loose at the headers and weave the pipes out somehow?
Wish you was closer, one thing I do do well at is getting stuff apart.
Wow Tim. Not good. Sorry for your pain......
Gearfinger
Well-Known Member
Good Morning, coffee mavins. Today I get to do something worse than scraping off old hard gaskets... replacing the seals in the brewing heads of the espresso machine. When old and hard, they must be dug out in small bits that resemble chunks of an old rock hard fan belt. Can't do anything till we close this afternoon, so the work and beer combo will be in effect
I think i pushed the pin out of the servo lever, and pulled the parts out of the band, that gave me room to get servo out. Mine broke, the snap ring let go. I had to make a mini c-clamp type installer to get pin back in i think. 15 years ago.
And I had the transmission professionally rebuilt by a mopar only rebuilds.... Grrrrr
Going on quest to see if pin installer still exists.
I’d be an *** and tow the whole car to them and tell to unfubar it.
Ok. I have no clue how this worked, but it was for pressing pin pack into servo lever.
IN PA!!!
Unconventional
Well-Known Member
I recall someone mentioning they had a couple of hoods they wanted you to move out East too
LOL. I am showing this car in the Carlisle show next year. Of course it needs to be good by then. And who knows what I am hauling east next year...I recall someone mentioning they had a couple of hoods they wanted you to move out East too
Unconventional
Well-Known Member
Cut the new exhaust near the front spring hangers so you can move the forward bits out of the way?
-
