RARE INTAKE MANIFOLD
All I can say is good luck with it. They also cut the whole separator out. so the dual plane advantage is gone. It is a cool piece but unless you have w2's or oval port Batten heads you would be better off looking for and old Wieand, Offenhauser, or a true LD340. You will have less issues. We have one he used on a plastic mock up motor picked it up for $75. Look at local track swap meets
I asked my son he said the angle may not have been changed. BHJ makes an intake angle gauge to check it . They are not cheap. BHJ Products.
Special spacers will have to be made and then double gasket it. He said its not worth doing it. We saw that intake it was around $300 on Facebook. Get a new air gap they fit nice. Todd has the intake off of this motor and others. Ask him probably get it reasonable
All I can say is good luck with it. They also cut the whole separator out. so the dual plane advantage is gone. It is a cool piece but unless you have w2's or oval port Batten heads you would be better off looking for and old Wieand, Offenhauser, or a true LD340. You will have less issues. We have one he used on a plastic mock up motor picked it up for $75. Look at local track swap meets
I asked my son he said the angle may not have been changed. BHJ makes an intake angle gauge to check it . They are not cheap. BHJ Products.
Special spacers will have to be made and then double gasket it. He said its not worth doing it. We saw that intake it was around $300 on Facebook. Get a new air gap they fit nice. Todd has the intake off of this motor and others. Ask him probably get it reasonable
