Allstar Performance ALL54224 Throttle Cable Bracket
You know, I honestly cannot recall what stud I used. I had several of them laying around and recall having to take some measurements and what-not. Was it a 4-speed stud similar to this eBay one?
I just cannot recall. I DO recall checking with some eBay vendors and having them measure some but I do not have any records showing what stud I ended up using.
The key as you note is to have the threaded part long enough to reach though the bushing. And also to get the 3/16" dia stud part where the throttle cable goes on - most of them are 1/4" and are too large (although a lathe could fix that - or even a hillbilly lathe like my drill press and file!). I know I also had the Edelbrock #8007 stud around here but no record if I used it. I'm sorry I couldn't get this across the finish line for you!
You know, I honestly cannot recall what stud I used. I had several of them laying around and recall having to take some measurements and what-not. Was it a 4-speed stud similar to this eBay one?
The key as you note is to have the threaded part long enough to reach though the bushing. And also to get the 3/16" dia stud part where the throttle cable goes on - most of them are 1/4" and are too large (although a lathe could fix that - or even a hillbilly lathe like my drill press and file!). I know I also had the Edelbrock #8007 stud around here but no record if I used it. I'm sorry I couldn't get this across the finish line for you!
