[Found!] 302 casting small block heads

-
Status
Not open for further replies.
Rockauto used to have them, reman.
Nice Job

Not listed right now, probably out of stock.

'87 to '91 Dodge 318 pickups.

Can find them in the salvage yards used. They have hardened seats.

Can Pop in new valves and valve guide seals and good to go again.

Closed Chamber Heads, they have nice big pushrod holes from the roller engines they were on.

Screenshot_20211125-232219_Gallery.jpg
 
Depending what you find in the salvage Yards. '89 - 91 D150s have the stock 9.2:1 pistons and free floating Rods too.

If you want to swap those higher compression pistons into your stock bore build.
Can probably buy a complete engine for the same price of the heads, have to see what's out there. Those are roller engines, but parts will swap over to the LA engines .

The roller pushrods are different Lengths than LA pushrods.

Screenshot_20211126-095119_Gallery.jpg


302 headed '69 318
 
Allied, ATK, auto zone, rock Auto just a few but I plan on using bigger valves and springs so I don't need a reman ready to go head so I am looking for a used set.
I wouldn't sell mine for less than 300 used and greasy. All of those places you need to call and find out if that casting is actually available still and the price plus core charge..and they don't sell them bare...so they'll be loaded ready to go and you'll have to scatter them for your big valves. I can have them in any order you want...but frankly I'm sick of all the talk that they're so desirable ...UNTIL YOU WANNA BUY SOME..then all the sudden theyre worthless and no one wants to pay. The 318 crowd can be the biggest bunch of double talking cheap skates sometimes. If those outfits have them..and at a affordable price. ..why are folks still asking for them here.
 
If anyone is looking for compression...know that switching to 302 heads as cast will be a trade in flow for 4-8cc smaller chamber.

If you have the 675 castings those are usually 68cc. and milling roughly .023 will yield a 64cc chamber after a deshroud cut. If you have later 70's, those are 72cc like most 360 heads and will need about .045 milled to be 64cc.
 
Open right now, I know I can buy them reman from different places so of course I don't want to spend more than they are reman

I'd recommend remanufactured ones. Shipping from anywhere is going to be the killer. :BangHead:
 
I wouldn't sell mine for less than 300 used and greasy. All of those places you need to call and find out if that casting is actually available still and the price plus core charge..and they don't sell them bare...so they'll be loaded ready to go and you'll have to scatter them for your big valves. I can have them in any order you want...but frankly I'm sick of all the talk that they're so desirable ...UNTIL YOU WANNA BUY SOME..then all the sudden theyre worthless and no one wants to pay. The 318 crowd can be the biggest bunch of double talking cheap skates sometimes. If those outfits have them..and at a affordable price. ..why are folks still asking for them here.
Thank you sir..went and took pics ,got shipping gave a price before i did this .this party was very interested and No Sale ..going with a remanned set..it was a big wast of time and gas..
 
Thank you sir..went and took pics ,got shipping gave a price before i did this .this party was very interested and No Sale ..going with a remanned set..it was a big wast of time and gas..
Hmmm you used the same pics to list them for sale here this past weekend, sorry if you think I wasted your time I went with a different set of heads sorry.
 
Status
Not open for further replies.
-
Back
Top