How do you tighten the LCA shaft?

Right on Brother! I had to hit them today, working on a " stranded" chicks 94 iszuzu amigo 2.6... we did good the other day, in a field, in the ground, about 3 hours, Not being Stressed, but getting it, had every thing dropped. Then the pilot bearing was stuck, went back today, w/ a puller from *@&$ badvance, post had round claws,went to auto zone, a cool ol bro helped Mr with a Brand New puller attachment, but no slide hammer. I have this stuff at my other place, if it ain't been stolen. So I leave the Zone, go to HF, and grab the Last 2# slide puller. Tapped it right out. Bearing was partially froze, one way. So I test fit new one on the input shaft... ARRRGGGHH!. THANK GOD I did. We would have killed that transmission, as we may have been mad enough to use bolts to press it on, breaking the aluminum bell... anyhow, Ace is the Place, 80g emery cloth, and an hour of pretending to sand copper for sweating pipe, got it to fit. Wait... gets better! Was looking up torque specs... Manufacturer says don't reuse Flywheel bolts! And I'm not having much luck finding any. Thing needs to go tomorrow...