nothingbutdarts
Well-Known Member
I am stumped & trying to find out if this shifter is a V-Gate or a Ram Rod. Thanks!
V-Gate or Ram Rod shifter identification.
- Thread starter nothingbutdarts
- Start date
-
Hyper_pak
Old School Chrysler Fan
Hurst Ram Rod.
Hyper_pak
Old School Chrysler Fan
There are 3 spacers, 3/8 long that go between the shifter and the mounting plate. Plate to trans extension housing, 3 spacers on the other set of bolt holes and then the shifter lines up with the shift levers on the side cover.
Definitely not a V-Gate Shifter
nothingbutdarts
Well-Known Member
Does anything need to be cut out anywhere in the tunnel area for this to be used on an A body?
Rat Bastid
Dunamis Metron
You may have to cut the lever stops off to get it in the hole. I always take them off. If you have a ball and detent cover, or even the interlocking side cover, there is a stop in them. Unless you lay on the shifter or something you don’t need them and they are in the way. Other than that it should fit in the hole.
-
