Pushrod length

Were the heads milled .010 ths to clean them up?

I don't remember what was done to the heads at that time. I know I did reuse the original pushrods.

The motor has run fine, but recently the valve train has gotten a little noisier. Hence the decision to adjust the valves.

It was late yesterday, so I didn't examine all the adjuster screws. I'll look at at the rest of the screws in a little bit to see if it's all or just one or two.

I was 16 when I built it, so I "thought" everything was "perfect", especially since it actually fired right up.