"Cheap" Weld Wheels: Ventura S104 - Opinions?

For 17’s in the front the maximum backspace for most rims is about 5.6” to 5.7”. That’s usually where the outer tie rod to rim lip interference issue comes up. It does depend on the design of the rim, but I only know of 1 guy that was able to run a 17” rim with a 6” backspace up front. And he even said later that the clearance was an issue. He was running Mustang Cobra’s, 17x9.

For the center bore, 72.56mm is ~2.8”. Most of the 73+ disk hubs are in the 2.7” range, so are DoctorDiff’s aluminum hubs for his 13” disk kits. So it will be close. The biggest thing is whether or not that’s the bore all the way through. Like my Enkei’s advertise a 73.1mm bore. And they start out at 73.1, but then they taper to a 65mm cap. And because they’re very thin where they mount up, the disk hub has to pass all the way through the rim. So I had to have mine machined, even though the advertised bore should have been fine.