Trick flow rocker shaft studs

Ted265 said
Hi all,
Just wondering if anyone has a set of the small block TFS-61400613 rocker shaft studs hanging around that they could measure the overall length of for me? Or does anyone know the length of these studs?
I contacted trick flow tech department last week to ask them for the overall length as they don't list it on their website, but yet to get a response back from them.
My PRW rockers came with studs but they are too short to accommodate my geometry correction kit.
Would rather run studs instead of bolts on the alloy heads if I can find some the right length.
Cheers,
Ted

I’ve got the TFs w/Erson rollers and Mike’s correction kit, and using the Allen bolts as supplied with the Angelucci billet (MP replicas) hold downs. had no concerns using bolts vs. studs.
Rotate the engine so as many lifters are on the lobe heels or at the lowest lift as possible, back the rocker adjusters out and alternately/incrementaly tighten down the hold down bolts.