Magnum Head Valve Spring Compressor
No worries.
I spent some time messing with it some more. Looks like it might work for the most part as is. I reversed the order and put the aluminum plate on top. This put the main plate lower and the center bolt in a much better spot. The only issue is that the center bolt is about 3 degrees out of plumb with the valves. If you look around the shadows (sorry about that), with the oversized hole, the plate that pushing the valve retainers down is pretty close to centered. At most maybe only a 1/16" off.
No worries.
I spent some time messing with it some more. Looks like it might work for the most part as is. I reversed the order and put the aluminum plate on top. This put the main plate lower and the center bolt in a much better spot. The only issue is that the center bolt is about 3 degrees out of plumb with the valves. If you look around the shadows (sorry about that), with the oversized hole, the plate that pushing the valve retainers down is pretty close to centered. At most maybe only a 1/16" off.
